RIFT Proton Systems Pack Reactor Owner's Guide

RIFT Proton Systems by Right Coast Props
RIFT DIAGNOSTIC PORTAL RIFT FIRMWARE UPDATER

STEP 1 · CHOOSE YOUR CONTROL SETUP

HOW DO YOU OPERATE YOUR PACK?

FOUR INTERACTIVE MODES · SYSTEM CHECK

SELECT OPERATING MODE

Use the Mode button to choose GB84, Afterlife, ChAoS, or RIFT Music Player before operating any pack controls.

MODE REQUIRED
LIVE RIFT VISUAL FEEDPACK OFF · STATIC
OPERATING MODENOT SELECTEDGB84 · AFTERLIFE · ChAoS · RIFT MUSIC PLAYER
AUDIO READY · SOUND ON
01 MODE02 POWER03 PRESTART04 STARTUP05 READY06 HOLD FIRE

HASBRO / HASLAB WAND

START, RUN, AND SHUT DOWN.

The steps below show the real-world operating order. Master Kill comes first, and the system retains the operating mode selected during the previous session.

Start the pack

  1. Master Kill Switch ON
  2. Confirm the retained mode, or use Mode to select another
  3. SW1 ON for prestart
  4. SW2 ON for the wand transition state
  5. SW3 ON for the full running state
  6. Wait until the white hat light on the wand begins flashing
  7. Press and hold Fire to fire, or press Fire to advance tracks in RIFT Music Player mode

Shut down the pack

  1. Release the Fire Button
  2. SW3 OFF
  3. Allow the wand to shut down; the pack follows after a short delay
  4. SW2 OFF
  5. Wait approximately one second
  6. SW1 OFF for final shutdown
  7. Leave Master Kill ON for the next startup, or switch it OFF when finished with the pack

INTERACTIVE SYSTEM TESTS

OPERATING MODES.

GB84, Afterlife, ChAoS, and RIFT Music Player are now fully interactive.

1 BLUE · INTERACTIVE NOW

GB84

Classic 1984-inspired startup, idle audio, red overlap Cyclotron effects, firing, and staged shutdown.

2 GREEN · INTERACTIVE NOW

AFTERLIFE

Afterlife-style startup with faster accelerating Cyclotron behavior and updated firing effects.

3 TEAL · INTERACTIVE NOW

ChAoS

Capacitor charging, unstable electrical effects, failed ignition, chaotic firing, overload, and dramatic shutdown.

4 ORANGE · INTERACTIVE NOW

RIFT MUSIC PLAYER

Nine soundtracks with dedicated startup behavior, automatic continuous play, and Fire-button track advance. This mode does not fire a proton stream.

PACK REACTOR MODULE

CONNECTION EXPLORER.

RIFT Proton Systems electronics components
5 VOLT IN

Regulated 5V DC input only. Verify positive and ground before powering the system.

⚠ 5–6V DC MAXIMUM.

The Pack Reactor Module is designed for a regulated 5V DC supply and must never receive more than 6V DC. Confirm polarity and disconnect power before adding or removing accessories.

SYMPTOM-BASED HELP

WHAT IS THE PACK DOING?

No lights or sound

Check the battery, regulated 5V connection, fuse if fitted, and Master Kill Switch.

Pack will not start

Return all operating controls to OFF, wait one second, then restart in the correct order.

Pack remains in prestart

Check the AUX / ON-OFF control and its wiring. Main activation has not been detected.

Wand will not fire

Allow startup to finish and wait for the white status light to flash before pressing Fire.

Pack shuts off after inactivity

This is the Hasbro wand auto-off. Return SW1, SW2, and SW3 to OFF and run the restart sequence.

No sound

Raise the volume and inspect the speaker connection. Use a total 4-ohm speaker load.

LEDs flicker

Check for a loose common ground, unstable power, or partially seated connector.

Vent does not activate

Check relay-control wiring and confirm the vent accessory has its own correct power circuit.

RIFT SYSTEM MANUAL

NEED EVERY DETAIL?

The printable manual includes full GPIO pinouts, component descriptions, specifications, ribbon cable behavior, disclaimers, and expansion information.

DOWNLOAD FULL PDF